Maintenance
MAINTENANCE OF FINISHES:
Below is a quick guide for caring for a Wired fixture. Note that as a custom lighting manufacturer, each fixture is unique to its owner, home & location in our beautiful world. Wired welcomes all inquiries regarding their specific fixtures and project to insure a long and beautiful life of the fixture.
· PAINTED FINISHES, PLATED FINISHES AND METAL FINISHES WITH A CLEAR LACQUER TOPCOAT SHALL BE MAINTAINED AS FOLLOWS:
· FIXTURES SHALL BE CLEANED USING A SOFT, NON-SCRATCHING CLOTH. CLOTH CAN BE DAMPENED IN PLAIN WATER OR A MILD, NON-CORROSIVE, NON-ABRASIVE SOAP AND WATER SOLUTION. DO NOT CLEAN FIXTURES WITH ANY CLEANERS CONTAINING BLEACHES, ACIDS, OR ABRASIVES OF ANY KIND.
· UNFINISHED, NON-SEALED OR NATURALLY AGING FINISHES CAN BE CLEANED PER ABOVE. CLEANING OR USE OF ABRASIVES CAN CHANGE THE APPEARANCE OF THESE FINISHES.
· USE EXTREME CARE WHEN CLEANING NEAR WIRE, SOCKETS, OR OTHER ELECTRICAL COMPONENTS TO INSURE THAT THEY REMAIN DRY AND FREE OF MOISTURE. FIXTURES SHOULD BE TURNED OFF OR DISCONNECTED FROM THE POWER SUPPLY WHEN BEING CLEANED TO PREVENT ELECTRICAL SHOCK.
· ACRYLIC/RESIN LENSES CAN BE CLEANED USING THE CLEANING SOLUTIONS NOTED ABOVE. WINDEX OR OTHER GLASS CLEANERS SHOULD NOT BE USED EXCEPT ON CLEAR GLASS ONLY; HOWEVER, ONLY IF THE LENS IS FIRST REMOVED FROM THE FIXTURE TO PREVENT OVERSPRAY ONTO THE ADJACENT METAL FINISHES.
· PLEASE CONTACT FACTORY SHOULD THERE BE ANY QUESTIONS REGARDING THE FINISH MAINTENANCE OF THE FIXTURES.
· FIXTURE CLEANING SHOULD BE DONE ON AN “AS NEEDED” BASIS AND NO LESS THAN ONCE ANNUALLY.
REPLACEMENT PARTS/FIXTURE COMPONENTS AND ASSEMBLIES:
· ALL FIXTURE PARTS, COMPONENTS, AND ASSEMBLIES CAN BE IDENTIFIED BY FIXTURE TYPE AND ORIGINAL PROJECT NAME. FIXTURES SHOULD BE INSPECTED WHEN CLEANED OR RELAMPED AND NO LESS THAN ONCE ANNUALLY TO INSURE PROPER FUNCTION AND STRUCTURAL INTEGRITY. PLEASE CONTACT FACTORY SHOULD REPLACEMENT PARTS OR SPARE PARTS BE REQUIRED. ALL GUARANTEES AND FIXTURE WARRANTIES SHALL BE NULL AND VOID IF FIXTURES ARE ALTERED IN ANY WAY OR IF THE FACTORY IS NOT FIRST NOTIFIED BEFORE ANY WORK COMMENCES ON THE FIXTURES LISTED ABOVE. SHOULD FIXTURES BE REMOVED AND REINSTALLED, INSURE THAT ALL SAFETY HARDWARE/CABLES ARE REATTACHED AND SECURE, ALL FASTENERS ARE TIGHTENED, AND THAT ALL ELECTRICAL AND MECHANICAL COMPONENTS ARE IN GOOD WORKING ORDER PRIOR TO PLACING BACK IN SERVICE.
Our Contact Information
Please contact us with any questions or comments about this policy, your personal information, our use and disclosure practices, or your consent choices by email at info@wired-designs.com.
Wired Custom Lighting
8690 National Blvd
Culver City CA 90232 USA
P. 1 310 229 9500